LAYERLOGIC PRO

WINDOW VENT SYSTEM
CONFIGURATOR v1.0  ·  COMPATIBLE WITH ANY FDM PRINTER
Window Measurements
mm  |  measure inside channel to inside channel
TOTAL WIDTH CH CH WINDOW SILL
Measure from inside edge of left channel wall to inside edge of right channel wall.
mm  |  default 28.15mm
SLOT TAB TOP VIEW — CHANNEL Use calipers. Measure gap between rails.
Measure the opening between the two metal rails with calipers. The cap tab slides into this gap.
mm  |  default 8.02mm
LEDGE WIDTH CAP BOTTOM SIDE VIEW
Measure the horizontal metal ledge at the bottom of the channel. The cap bottom slot sits over this ledge.
mm  |  default 163mm
FRAME HEIGHT WINDOW SILL WINDOW GLASS
Measure from the top of the sill ledge up to the bottom of the window frame rail. This is the panel height.
mm  |  default 45mm
Vent Configuration
mm  |  measure the valley OD of your hose (across the grooves, not the peaks) — collar is a spigot, hose slides over and clamps down
OUTER DIA Measure outside of hose with calipers. Default: 99.5mm
Measure the outer diameter of your flexible exhaust hose. Use calipers for accuracy.
Printer Bed
mm  |  enter your printer bed length
mm  |  clearance from bed edge
Fixed Panel Sizes
mm  |  default 76.2mm (3")
mm  |  default 152.4mm (6")
LayerLogic Pro Window Vent System
ASSEMBLY GUIDE
End cap
Tab slides into vertical channel
Vent panel
Hose clamp lip collar
Middle panels
Scaled to your window width
Biscuit joints
20mm tabs lock panels together
Top U channel
Window lowers into this slot
Bottom channel
Sits over window sill ledge
Enter your measurements and hit GENERATE
STL files built in your browser · No OpenSCAD needed
COPYRIGHT NOTICE
© LayerLogic Pro — Window Vent System. All rights reserved.
This tool and its generated STL files are provided for personal, non-commercial use only. Redistribution, resale, or modification of generated files for commercial purposes is prohibited without express written permission from LayerLogic Pro.
STL generation occurs entirely in your browser. No data is transmitted or stored. Compatible with all 3D printers.